1. Prepare the natural nail as usual and apply I.Am Blue Scrub to the natural nail plate. Allow to dry completely before applying I.Am Collection by BO. Base Gel.

2. Apply I.Am Collection by Bo. Base Gel - Wipe the brush on the neck of the bottle to remove excess product. Apply a thin layer to the free edge of the nail to ensure durability and prevent the product from shrinking. Hold the brush horizontally on the nail and apply a thin layer of I.Am by BO. Base Gel over the entire nail, from the cuticle to the free edge. Cure all four fingers together for 120 sec. UV / 30 sec. LED. Repeat these steps on the other hand and then on the thumbs. Optional: brush with a clean gel brush to remove excess sticky cured base gel to reduce the chance of shrinkage and to apply a smoother color.

3. I.Am Collection by BO. Gel polish application - Rub the bottle upside down between the palms of your hands to ensure that the color is well mixed. Seal the free edge with I.Am by Bo. Gelpolish to ensure durability and prevent color shrinkage. Hold the brush horizontally on the nail and continue to the center of the nail. Move the brush from the center of the nail up to the proximal nail fold and then stroke down to the free edge. Make sure the gel polish does not get on the skin. If the gel polish has touched the skin, remove it before curing the nail with the I.Am UV Cleanser and a Cuticle Pusher. Cure all four nails for 120 sec. UV / 30 sec. LED. Repeat the steps on the other hand and thumbs.

4. I.Am Collection by BO. Gel Polish - Apply a second thin layer of gel polish following the same steps. This layer will provide full coverage. NOTE: If you have a highly pigmented complexion or are using a different lamp, you may need to cure an extra time to ensure the color is fully cured and does not bleed during your Top Gel application.

5. I.Am Collection by BO. Top Gel application - Wipe the brush on the neck of the bottle to remove excess product. Seal the free edge of the nail to ensure durability and prevent the product from shrinking. Hold the brush horizontally on the nail and apply a thin layer of I.Am by BO. Top Gel to each nail surface of all four nails on the hand. Cure all four nails for 120 sec. UV / 30 sec. LED. Repeat on the other hand and finish by applying to the thumbs.

6. If you are using I.Am Collection by BO. Sticky Top Gel, it will be necessary to remove the sticky layer after curing. Saturate a gel sponge with I.Am UV Cleanser. Wipe away the top sticky layer with light pressure. NOTE: Do not wipe the nail again with a used part of the gel sponge, as this will redistribute the sticky layer, causing the Top Gel to become dull. Use a clean, saturated gel sponge for each finger. Tip: Wait about 1 minute after curing before removing the sticky layer to allow the nails to “cool down” for even more shine.

Removal

1. Use I.Am Hydra Spray or I.Am Hand Gel.

2. Remove the seal on each nail with an I.Am 180/180 Straight File. Soak a Nail Foil with I.Am Soak Off Gel Remover and attach the foil firmly around the finger.

3. Leave the Nail Foil on the finger for ten minutes. Pull the Nail Foil and product off the fingernail with a twisting motion.

4. If necessary, carefully remove excess Gel Polish using a Cuticle Pusher. Be sure not to scrape away the surface layers of the natural nail plate.